Magnetic Door Holder Fitting Instructions

Mark the position for the keeper plate on the door.

Magnetic door holder fitting instructions.

Check the rubber ring is fitted before screwing the keeper plate to the door. This may be something like a maglock or a yale door release for the installation all you re doing is connecting the door intercom to the screen and the screen with door release button to the door release mechanism meaning that you can see who s at the door and then press a button to release the lock on the door. If you re trying to install and can t seem to get it open because its stuck. Our products are available in satin nickel satin chrome polished chrome satin and polished stainless steel white polished brass and matte black finish.

Watch this video to show you how to open that stubborn magnetic doorstop. To locate the two mounting holes in the door hold the contact plate centered against the magnet open the door and press against the transfer marking points on the armature base. When power is restored the magnets will re energize permitting the doors to be manually returned to their held open position. For doors fitted with overhead closers a position towards the top of the door is best.

Add the spring so the narrow end sits inside the button and the wide end will sit against the plate. We also sell hook auto door holder hinge pin door stop door holder overhead doorstop and door stop and hook. Step 5 press the assembled catch body against the plate and turn clockwise to connect the catch body and plate together. Be released thus allowing the door closers to close the doors.

Gently close the door and adjust the angle of the door armature so the base lays flat against the door. Decide where the door holder will be mounted at least 650 mm from the door hinge. Place the button shaped magnet into the body section so that it sticks through the hole. Place and center the door armature on the surface of the magnet with the two holes of the base aligned horizontally.