Indeed the second method is.
Magnetizing steel sheet.
Put the miniature on the magnet and glue.
Using an ac power source will also work but is not recommended because it is high voltage and there is potential for.
At each end of the horizontal bar place a vertical bar.
It causes the non magnetized metal to polarize and turn into a magnet.
Strip the insulation off both ends of a wire.
Put glue in the bottom of the miniatures base.
Soft ferromagnetic materials are iron and its alloys with nickel cobalt tungsten and aluminium.
Place one bar horizontally.
Select a low voltage.
Leaving a couple inches several centimeters of wire at each end wrap the insulated.
Place light pressure on the magnet and rub the metal in one direction only.
The magnet must make as much contact with the metal as possible.
Arrange them in a circuit pattern.
Using wire stripping pliers strip about 1 in 2 5 cm of insulation.
Put a glob of hot glue on the pan with silicon sheet put a magnet int he middle of that glob.
Place the four pieces of iron or steel on a flat surface.
The insulated copper wire needs to be thin enough to easily wrap around the metal and long enough to wrap a few dozen.
When dry peel away from the silicon sheet.
Rub the metal you want to magnetize in one direction over the existing magnet.
Wrap the wire around the steel.
Silicon steels and cast steels are the most important ferromagnetic materials for use in transformers and electric machines.
Select a low voltage battery.
Magnetize steel using a battery 1.
Strip the insulation off both ends of a wire.
Make sure the metal has no magnetization before beginning.
Magnetizing place the magnet at one end of the piece of metal.
Fe2o3 where me represents a metallic ion.
Wrap the wire around the steel.
Using wire stripping pliers strip about an inch 2 5cm of.
