Going to start a thread to see if anyone has attempted this.
Maytronics power supply not turning on.
Are you happy with what you learned here.
Check the full filter light indicator ensuring that it s off.
Power supply not rated yet our power supply for our dolphin 3001 will not turn on.
Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.
After 1 min connect your smartphone to wifi.
You ll know the app is connected if the power supply buttons are overridden in disable mode.
See the relevant section below for more details on each program.
In essence what you ve just done is zero out the sensor.
Pair via bluetooth to your dolphin not a neighbor s.
Plug the power supply into an electrical outlet.
Check the label on your transformer for voltage output and type.
If the psu turns on and the lights stay on the problem is not with the psu.
Turn the power supply off.
Wait 30 seconds then turn it back on.
Check power to the socket and reconnect pool cleaner.
Output voltage should be about 38 volts d c.
There may be a problem with the blue cable or the dolphin cleaner itself.
What about damaged filters.
If no program is selected the robot will perform a single cleaning cycle.
We had been using it then i shut it off to clean out filter and it will not come back on.
Open the impeller cover and check that nothing is trapped in the impeller.
Unplug the power supply.
As a result that light shouldn t turn on again until the filters begin to fill up or are full.
You can program the power supply at any time.
Close the unit casing turn it on and let it run.
The pool cleaner moves but.
Open the impeller cover and check that nothing is trapped in the impeller.
Unplug the power supply.
Wait 30 seconds then turn it back on.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
Unplug the blue cable from the power supply unit psu and turn it on.
A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c.
If the outlet is receiving power.
To check your maytronics diagnostic power supply use a multimeter set to 200vdc.
Wait 30 seconds then turn it back on.
It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.
Press the on button the leds will turn on and the robot will start to operate.
Turn the power supply off.
